Example 2 calculated document thickness is 0.11mm (210x297 80gsm) and the required fold is V fold then the final document in the envelope will be 2 thicknesses so the thickness needs to be set to 0.22mm) Note. To correct this information de-select the autocalc and manually enter the thickness based on the fold (Example1: calculated document thickness is 0.11mm (210x297 80gsm) and the required fold is C fold then the final document in the envelope will be 3 thicknesses so the thickness needs to be set to 0.33mm. Depending on the required fold the document will be twice or three times as thick as a single sheet. This data is incorrect for the TQM and needs to be adjusted manually. When the sizes of the document and the paper weight are defined, then the document thickness and weight are automatically calculated. This data is then passed to the TQM.ġ3 When a new document is created to be run on a AM5 folder its parameters are also entered in the document setup screen. (The PFE sequence will only re-set on a job change) Document set up for using AM5 with TQM When a new document is created to be run on a AM5 feeder its parameters are defined in the document set up screen. The TQM sequence start position will be re-set after a job change and a clear and restart and will need to be re-entered before the job is run. If the TQM sequence start number is not set then the following error message appears Note. (All data from the current job has been sent to the TQM)ġ2 The TQM sequence start number must be entered before the job can run. The reset command is the last command to be sent and signifies that no more operating messages will be sent. If last EOG is diverted or removed from the AM5 then this data will be sent to the TQM after the Autoend is complete and before the reset command () is sent. This tells the TQM that the job is complete and there is no more data for that job is to be sent. Job Complete Message When the AM5 is idle (all operating messages have been sent) the reset command will be sent to the TQM. Please ensure the TQM system is powered on and ready to receive the configuration settings. The AM5 expects the TQM3 System to respond with or if neither of these messages has been received by the AM5, before the run button is pressed then the following error message will be displayed. 10 Configuration Responses When the configuration is sent to the TQM by the AM5 it starts with and ends with (as per the protocol document).
0 Comments
Leave a Reply. |